Msi Ms-7613 Motherboard Manual
Please install the CPU into the CPU socket as shown below.ImportantAlways unplug the power cord from the power outlet before installing or removing the CPU.Please retain the CPU protective cap after installing the processor. MSI will deal with Return Merchandise Authorization (RMA) requests if only the motherboard comes with the protective cap on the CPU socket.When installing a CPU, always remember to install a CPU heatsink. A CPU heatsink is necessary to prevent overheating and maintain system stability.Confirm that the CPU heatsink has formed a tight seal with the CPU before booting your system.if(typeof ez_ad_units!='undefined')ez_ad_units.push([[250,250],'manuals_plus-small-square-2','ezslot_30',917,'0','0']);__ez_fad_position('div-gpt-ad-manuals_plus-small-square-2-0');Overheating can seriously damage the CPU and motherboard. Always make sure the cooling fans work properly to protect the CPU from overheating. Be sure to apply an even layer of thermal paste (or thermal tape) between the CPU and the heatsink to enhance heat dissipation.Whenever the CPU is not installed, always protect the CPU socket pins by covering the socket with the plastic cap.If you purchased a separate CPU and heatsink/ cooler, Please refer to the documentation in the heatsink/ cooler package for more details about installation.DIMM SlotsPlease install the memory module into the DIMM slot as shown below.ImportantTo ensure system stability for Dual channel mode, memory modules must be of the same type, number and density.if(typeof ez_ad_units!='undefined')ez_ad_units.push([[468,60],'manuals_plus-mobile-leaderboard-1','ezslot_9',918,'0','0']);__ez_fad_position('div-gpt-ad-manuals_plus-mobile-leaderboard-1-0');Some memory modules may operate at a lower frequency than the marked value when overclocking due to the memory frequency operates dependent on its Serial Presence Detect (SPD). Go to BIOS and find the DRAM Frequency to set the memory frequency if you want to operate the memory at the marked or at a higher frequency.It is recommended to use a more efficient memory cooling system for full DIMMs installation or overclocking.The stability and compatibility of installed memory module depend on installed CPU and devices when overclocking.Please refer to www.msi.com for more information on compatible memory.M2_1: M.2 Slot (Key M)Please install the M.2 device into the M.2_1 slot as shown below.
Msi Ms-7613 Motherboard Manual
This connector is for TPM (Trusted Platform Module). Please refer to the TPM security platform manual for more details and usages.JCI1: Chassis Intrusion ConnectorThis connector allows you to connect the chassis intrusion switch cable. 041b061a72
